My RB912UAG-2HPnD failed to boot into NetInstall mode. I first used the Reset Button and all the LED's came on but they never blinked nor did the unit beep. I powered it down then I tried to use the jumper hole and the unit behaved the same way as the when I used the Reset Button. The RB912UAG-2HPnD...

So, I pulled out my RB912UAG-2HPnD that had not been used in several years. My eventual goal was to connect a verizon hotspot via usb for internet access. I successfully reset the factory settings and logged into it. I planned to update the firmware and RouterOS. For reasons I do not understand the ...

I want to mount my MIkrotik AP on a ceiling without using screws. Does anyone know of any adhesive hooks? right now I plan on using industrial strength velcro but now I am wondering about removing that eventually....

Ok I am finally revisiting my CRS125. I reset the settings and have started over. I have renamed all the ports ether1-ether24. ether1 doesnt have a master port and i left the 192.168.88.1 IP address. ether2 is the masterport for ether3-ether24. ether2 has an IP address of 192.168.5.1 ether1 is the W...

After successfully setting up a Mikrotik wireless access point, I decided to take the plunge and finally replace my apple time capsule as my router/switch with a CRS125-24G-1S-RM. So far, I have renamed every port ether1-ether24....I have then created ether1 as its own master and then ether2 as its ...

I am having problems setting up my RB912UAG-2HPnD as a simple wireless access point. My firewall is a separate device that provides DHCP and NAT. I am new to RouterOS. The wap is running ROS 5.26 and I cannot upgrade because it is telling me I have no internet connection. My wireless device is not g...

I am new to Microtik and RouterOS. I want to use my 912UAG-2HPnD firmware 3.17 and RouterOS version 5.26 as basic wireless access point. I am using webfig. Currently, my firewall is a separate appliance (not a Mikrotik device) that provides NAT and DHCP. In my firewall, I have setup 2 reservations f...