That was evil... well played!
https://mikrotik.com/product/crs317_1g_ ... estresultsMarvell 98DX8216
How much mpps can handle per second? does some one know ?
It‘s an SFP+ port, which requires SFP+ Gbics or Transceiver. The S+RJ10 should work.And why is the RJ01 not supported?
Nope. It's crapdoes Realtek RTL8367 manageable switch and support acl?
Where do you get this updates ?
Thanks in advance!
Rule of thumb: if it has more than one cpu core it will not run Metarouter.I should have said that I'd like to use MetaROUTER, which I think is not possible on arm yet? Does it work on PPC?
You can't always have it all I suppose.
confirmed, RouterBOOT upgrade installed ok on hAP ac². Upgraded from ROS 6.41.3 to 6.42rc49, then from RouterBOOT 6.41.3 to 6.42rc49 without any problems.*) routerboot - fixed RouterBOOT upgrade process (introduced in v6.42rc);
Very nice! Would love if this mechanic could be added to the other CSS/CRS RM models as well.The system runs silently, but there are two fans for situations where ambient temperature gets close to maximum. They will run automatically and only when it gets too hot.
Very much looking forward to this myself, too.The performance of the CPU for routing tasks will be published shortly on this page:
Does this fix the IPSEC packet re-ordering problem?*) ipsec - updated tilera classifier for UDP encapsulated ESP;
When it's done™Do anyone know when Mikrotik start RC ?
Picture shown in original post showed two LEDs with PSU1 and PSU2 next to them. That'll be a definitive yes.Finally, are there dual power supply options?
With 40MHz channel width and 1 data stream you won't get 100Mbit of actual user data rate out of that 801.11ac P2P link.its 40 MHz. we are not getting bandwidth on 5MHz 10MHz and 20 MHz
Connect via Winbox "Neighbours" to MAC Address of the device. Username and password remain the same.I screwed up setting. Can not connect to the unit. How can I reset the hAP AC? It is powered through POE.