Search found 3 matches
- Mon Feb 15, 2016 4:53 pm
- Forum: General
- Topic: Possibility of multiple trunked vlan master ports on single CRS125 switch chip?
- Replies: 4
- Views: 4339
Re: Possibility of multiple trunked vlan master ports on single CRS125 switch chip?
Bingo! Thanks again. Here's my working config, for anyone else that's curious. ether1-master and ether2 are connected to router management VLAN set to 100, gateway set to router NOTE: all VLANs are logically defined on ether1-master via "/interface vlan" All routing takes place 'above' mik...
- Mon Feb 15, 2016 3:08 pm
- Forum: General
- Topic: Possibility of multiple trunked vlan master ports on single CRS125 switch chip?
- Replies: 4
- Views: 4339
Re: Possibility of multiple trunked vlan master ports on single CRS125 switch chip?
CRS VLAN configurations do not work well with multiple master-ports. <snip> Since you have different VLANs in each of group you can use one master-port without any problems. The VLANs will be isolated anyway after configuring VLAN filtering http://wiki.mikrotik.com/wiki/Manual:CRS_examples#Unknown....
- Mon Feb 15, 2016 5:11 am
- Forum: General
- Topic: Possibility of multiple trunked vlan master ports on single CRS125 switch chip?
- Replies: 4
- Views: 4339
Possibility of multiple trunked vlan master ports on single CRS125 switch chip?
I just configured my CRS125-24G-1S-IN (6.34.1), and ran across a strange issue. I followed this guide: http://wiki.mikrotik.com/wiki/Manual:CRS_examples#Port_Based_VLAN General traffic flow is: wan/cpe -> router eth0 interface or eth1 interface -> switch -> access layer Ideally, I would like to have...