There is a caveat which is not obvious. Frames entering the switch which are to be forwarded to the CPU port are handled in a different way than those forwarded to another ethernet port. So even if you set up the VLAN handling using the /interface ethernet switch branch of the configuration tree, y...

Hi guys, Just wanted to let you know that the issue is resolved. Your original configuration looks fine It not only looks fine, it's proven to be fine as well 8) Before starting to fiddle around with the Bridge VLAN filtering I took another backup. After posting my results on the board and reading s...

Just for testing, I configured the bridge VLAN table and enabled Bridge VLAN filtering, hence HW offloading got disabled. First thing I noticed was that switch port settings interfered with bridge port settings... Switch ports were still configured with VLAN mode = secure and PVIDs. I believed the s...

Here is the complete export: # nov/05/2019 18:36:35 by RouterOS 6.44.6 # software id = ZBUE-6X7V # # model = RouterBOARD 3011UiAS # serial number = *removed* /interface bridge add name=bridge1 protocol-mode=none /interface ethernet set [ find default-name=ether1 ] speed=100Mbps set [ find default-na...

Sorry for kicking this thread up. Just wanted to confirm it finally works :-) Did you try it within the UPC Wi-Free network? Tried it on the Belgian Telenet WiFree network. Can confirm it works. Is it possible to use a RB2011 or any other wireless RB as wireless client with WPA2-Enterprise client (W...

Hi guys, I have the following setup with an RB3011 device. Two WAN ports (ether1 and 2), not bridged and switch chip 1 not used. A bridge with ether6, 7, 8, 9 and 10 as its ports using hardware offloading. Switch chip VLAN table is used as well. Ether6 is the trunk port while ether7 to 10 are access...

I don't get it... This thread is nearly five years old and the feature's still not available. Though, in these areas PEAP MSChapV2 is very commonly used. How about the rest of the world?