I'd seriously doubt this argument: pppoe usually is a user-context process, while bridges are done in kernel-context.For sure, use one PPPoE Server per VLAN. Much better than bridge them
how did you get ospf3? I'm testing on two CRS317 which converge fine in ospf2, but never using IP6Upgraded a CRS305 and CRS309 without any issues so far. OSPFv2, OSPFv3, HW L3. Just need to verify DHCP has been fixed.
MRI?Most tutorials recommend MRI to be set at 1600
well got this exact answer: will not be fixed in V6, will have to hope for ROSv7 to get mpls and bgp vpnv4 working in a multipath-setup.we asked MT support for help, maybe we can get help - if it says ROS7 I guess we will have to install cisco boxes again...
not me@hknet please, don't mess up count of NAT rules with conntrack table size limit.
+2+1 for security announcement mailinglistRSS is good, but will be nice to have some mailing list for security announcement and firmware update
q.e.d.I don't know the inner workings of CRS3xx but...
the original poster was never talking about inter-vlan-anything maybe you should revisit the original problem-report.it should do 10Gb within the same vlan but not intervlan
Doesn't look like it, though the Marvell 98DX8216 is a metro chipset (marvell's words) which would suggest 802.1ad should be available at the HW level.As other people wonder - Are we/Have we gotten hardware support for QinQ?
second that.12 x SFP+ (10G)
4 x QSFP (4x10G)
1 x Management (no PoE)
1 x serial management
second that. if you could talk your upstreams into limiting your bgp-view (ie only local routes and no full feed) you might still have fun with CCRs.Did not found how to pm here. Wonna honest answer? Go mx80 for your business.
fyi - tested l2tp-server on CHR v6.36.3 - works fine - maybe you should elaborate your problem.Problems with server l2tp!!!
well, removed it for the time being, as I like stableIt is best to avoid BFD until v7 is released.
my @cmd = ("/routing/bgp/peer/print","=status=","?remote-address=". $ng->get('peer'),"=.proplist=prefix-count");