Recommending you first read this excellent resource with examples.......... https://forum.mikrotik.com/viewtopic.php?f=13&t=143620 This one is not to bad either. https://wiki.mikrotik.com/wiki/Manual:Bridge_VLAN_Table Well, the thing is... I know how it's supposed to work, and as I said, most o...

Hi, I'm having some issues with vlan configurations not being applied using the bridge functionality... Normally everything is working as expected. I set up my vlans, I add some ports to the bridge, set pvid for the ports and set my tagged und untagged ports on the vlans, and it works as intended. B...

I'm having the same issue. Sometimes the 5GHZ network disappears after just a few hours, sometimes a few days. I tried upgrading to the beta firmware (because it mentioned stability issues with ARM wifi devices) but that didn't change anything.

I upgraded a RouterBoard hEX from 6.41 to 6.41.2 and had bridge ports disappearing too.

ether1 and ether2 were no longer part of any bridges (which was kinda unfortunate as those were my uplink and local-network ports)

Same issue here, router is announcing its ip + dynamic pppoe dns servers instead of the configured dns-server. Redid the configuration about three times until I recognized that it must be a RC bug... (Ugly but working) temporary solution would be a firewall dnat rule or just a forward-reject like th...

Since nobody replied I looked for a replacement SFP+ module and I bought some customized transceivers from fs.com, they are cheap and are working great.

Hey, I'm having trouble getting the SFP+ ports on the CRS226 working. I've connected two Cisco FET-10G modules to the switch and connected them in a loop (with loop detection disabled as a precaution) to eliminate any outside faults, but I can't get a working link... The SFP section in WinBox looks ...