Hi All,
just realised, 2.4GHz-G-Turbo mode has been missing in RBs, but available when using PC Router with wireless PCI (AR5413 chipsets), v.2.9.27 & 2.9.38
Can someone from MT please confirm? or if there’re settings that i’ve missed with RB?
Thanks!
Oops, wrong room, can someone please move my post to wireless section? 
Make sure that frequency-mode and regulation-mode are the same on both and 2.4GHz-Turbo is allowed and supported by card.
make sure that your card is capable to support Super G mode … AR2413 doesnt support 108 mbps , the AR2414 BB MAC card does support 108 mbps … since the mikrotik software shows always AR2413 also for AR2414 cards dont get confused and check your card and manufacturer datasheet for more information what chipset your card is using.
I’m using NMP8602 mPCI on both PC Router and my RBs. Same mPCI same chipset. Both operating using superchannel frequency mode (i assume there’s no country restriction on this mode right?).
Here are some info on PC Router, v.2.9.38
0 interface-type=Atheros AR5413
chip-info="mac:0xa/0x5, phy:0x61, a5:0x63, a2:0x0, eeprom:0x5003"
pci-info="01:04.0" capabilities=tx-power-control,ack-timeout-control,
virtual-ap,alignment-mode,noise-floor-
control,scanning,burst-support,nstreme,
sniffing,compression,power-channel
default-periodic-calibration=enabled
supported-bands=2ghz-b,5ghz,5ghz-turbo,2ghz-g,2ghz-g-turbo,5ghz-10mhz,5ghz-
5mhz,2ghz-10mhz,2ghz-5mhz
and RB333, v.3.0rc6
0 interface-type=Atheros AR5413
chip-info="mac:0xa/0x4, phy:0x61, a5:0x63, a2:0x0, eeprom:0x5003"
pci-info="00:11.0" capabilities=tx-power-control,ack-timeout-control,
virtual-ap,alignment-mode,noise-floor-
control,scanning,burst-support,nstreme,
sniffing,power-channel,wmm
default-periodic-calibration=enabled
supported-bands=2ghz-b,5ghz,2ghz-g,5ghz-10mhz,5ghz-5mhz,2ghz-10mhz,2ghz-
5mhz
upgrade to the RB333 to the newest RouterOS version and check again.