2 LTE routers and a CCR1036

RouterOS Beginner Basics
1

Hi there.
I’m new here so if this is the wrong place to ask just say so,

I live at the country site so I have very poor mobile broadband connections. Therefore I will try to install 2 SXT-LTE6 antenna with 2 different mobile providers in different directions at my roof. Is it possible to set them up as some sort of load balancing and is the POE2 output able to draw the second antenna.

I have a R7800 with DD-WRT installed to provide wifi in my house.

Any one with same setup or ideas to solve this?

EDIT:
I found a CCR1036 at the job. Maybe it is easier with this unit

2

You can use passthrough mode on both SXT to get directly on your R7800 the IP of your ISP’s. The question is if your R7800 can do a load balancing.

Regards.

3

I found a CCR1036 at the work.
Now I have connected the two LTE routere to a dahua switch and with one cabel down to ETH1 at the CCR1036. I have set up DHCP on ETH2 and bridge all other lan ports to this network

4

So, you can use both SXT on pass-though mode. On CCR → ETH1 to SXT1, ETH2 to SXT2 and ETH3 or more ports as LAN. Your R7800 should be connected on LAN section to provide Wi-Fi.

ETH1: WAN1 → SXT1
ETH2: WAN2 → SXT2
ETH3: LAN → Dahua Switch → R7800

CCR can be the load balancer.

Regards.