260GSP "current too low"

SwOS
1

Anyone ever experience this? Was it resolved?

I have two 260GSPs plugged into a CRS. Both of the 260GSPs are powered using the power supply that they come with directly plugged in. The 1st GSP is powering 3 x BaseBox 2. And it is working fine. The 260GSP is powering 2 x wAP ac and a BaseBox 2. On two of the ports (Port 3 wAP and Port 4 BaseBox) when set to auto I get “current too low” and the devices just continuously cycle. If I set them to “on” they seem to turn on but it only reads 30 to 40mA… much less than the 100 to 200 the other wAPs and BaseBoxes use.

Thoughts?

2

you need a stronger power supply. It’s telling you that the current going into the switch is not enough to power the switch and the devices connected to it.

3

It shouldn’t be though. This is using the 24V 2.5A power supply it comes with?.. It should be able to power the three devices each using 200mA a piece without a problem.

Other ideas?

4

You have 2500mA to work with.

the wAP AC max is 500mA
the base box 2 is 416mA
the 260GSP is 250mA

That brings you to 1666mA or 1.6A.

So yes, you should be just fine - assuming that the power supply isn’t failing.
Have you tried switching the power supplies?

5

others thoughts would be that the switch is failing.

6

Have you verified the power supply? Use it for the working switch and see if it works ok. Just to rule out a defective power supply.
Next step would be to connect the ones not working into a port of the working switch.
If everything turns out ok, you have a defective cabling…

7

I contacted the distributor… either the power supply or switch. they are sending a new one.