I have a RB260gsp (1.14) that stops passing traffic through its ports. As soon as I reboot it, it starts working again for a day or so.
I notic a lot of “pause” packets on certain ports, could this be related. what can i do to fix it? there are no vlans or any config at all besides IP
+1, I’m seeing something similar to this.
I have the 260gsps installed on a MoCA network, and from time to time the web admin page becomes unresponsive. I have yet to do further investigation on whether the switch is responding to ping, etc. Having said that, a simple power cycle solves the problem quickly. Any one else seen this before?
+1, I have the same issue. Haven’t conducted a full diagnosis, but here’s my setup.
I have 2 rb260gsps connected to MoCA endpoints in my house. MoCA end points are used to drive faster-than-wireless internet traffic to my main media centers. From time to time, connectivity cuts out, and the RB260gsp devices do not respond on web-admin. I have not yet tried to ping to devices, etc. A quick power cycle brings the traffic back quickly.
My issues stopped after disabling flow control on the ports. MT support said look for “pause” frames, if they are there then flow control off will help