What’s new in 3.7:
*) improved simple queue list updating;
*) fixed p2p edonkey protocol matcher on rb600;
*) fixed booting on CR;
*) fixed problem - CF did not work on routerboards;
*) fixed ping to 2001::1 like IPv6 addresses in console;
*) made ISDN work again;
i think there is more fixed things not described
:>
Where are the pppoe performance fixes???
*) improved simple queue list updating;
this is it
:> one more thing :> thank u for the fix of double
thruoughput on rb600 ether interfaces :>
sorry.. newbie here, what is CR stand for??
*) fixed booting on CR;
Cross Roads
I have an x86 box here which is very strange.
Currently running 2.9.51, everytime I try to upgrade it to 3.6, just hangs on booting kernel.
Even installing 3.6 from ISO on it fails.
I’m wondering whether it’s worth trying to upgrade to 3.7, anybody had an issue like this before ?
edit: I should mention it is off site, so it’s a pain in the ass to re-install if it fails.
what hardware do you use ???
Just an Intel board, sata drive.
try to upload upgrade packages to your router using WinBox or FTP and reboot your router
So don’t use the .npk file and upload the packages individually ??
It doesn’t matter, but I always prefer individual packages because I only upload packages I need.
Yeah tried it, no good.
any experiance on large pppoe concentrator deployment (>700 clients)?
regards
Ros
it’s reported that there are no problems. here: http://forum.mikrotik.com/t/pppoe-server-performance-and-packet-lose-problems/19891/66
Hello everybody,
i have 2 MT3.6.
before i upgrade from 3.6 to 3.7 my free Momory status was 512 MB but after i upgrade to 3.7 with same configurations the memory status down to 126 MB on both of them. any one can help ?
best regards