Hey All,
Somebody out there has to have done this so here goes. I want to add jumpers to poe port(ether1) to carry over poe to ether2.Some confusion on my part as to how the pcb pinout is numbered, from the top 1 thru 8 left to right or right to left.If you’ve done this and have a pic I’d sure appreciate it.Thanks!!
Nobody…awww c’mon…
While I have never done this before the premise would be to pass pins 4,5,7,8 from ether1 to ether2 in the same order. I would guess that you could not get 4,5 wrong since they are the middle pair and use a volt meter to find 7,8. Another way to check which side 7,8 is the side the brown pair goes in on.
-Letni
Have a look near the end of the RB750 PoE Mod.
Works on an RB493 …