Last week I recently updated routerboard RB2011UiAS-2HND-IN to new OS version 6.17.
on friday thre was a recent power failure in local power supply provider, and since than on Display I see only starting services for 4min and than just keeps rebooting.
Unfortunately in this rebooting state it’s not managable, therefore question is if I can get into router and at least harvest logs ,or start single mode in order to avoid services failures.
what actualy I Can do without console?
Same thing happened to me but on RB951.
Net install fixed it after I thought it was gone.
Hello guys from MikroTik, had a problem with RouterBoard SXT Lite2 2.4GHZ
Model RBSXT2nDr2 when
updated to version 6.15 for 6.17 on the date of 07.23.2014, as follows.
1 -) did update via cable and RouterBoard and everything was
normal. installed and worked OK.
2 -) when turned off the electric power the roterboard reconnect the
RouterBoard did not return.
3 -) IP and MAC did not return and were hidden
Regards.
i have 2 bricked after upgrading to 6.15 on 2011. Netinstall failed to discover the device. Give it a reset it will work only till next reboot.
I just had two SEXTANT G 5HPnD’s do a similar thing. I have a ‘config’ file that I paste to term window when I’m setting up. Both were 5.2x. Worked fine after setup in the van. Once it was installed, all the led’s blink in a repeated pattern. After second one did it, I checked CAT5 with a fluke tester. It showed pins 1&2 and 4&5 were crossed instead of 4-5, 7-8. I ran new CAT5. Same thing.. I plugged one back in at our van, and got the same pattern of blinkiing LED’s. Installed a SXT and no problem.
If I press the reset button and plug in, it will boot fine and work until the next power cycle.
I’ve done several since without issue.
Hi…
the new OS version 6.18 solved all the problems found in the previous version.
kind regards