Active Backup Bonding Down and up-delay not working

RouterOS General
1

Hi,

we have an issue with RouterOS ignoring the up/down delay on the bonding interface.

I can see that this question/bug was mentioned in this thread with no response:
http://forum.mikrotik.com/t/bonding-down-and-up-delay-not-working/37436/1

Have tried adjusting the values to a higher value and hasnt made any difference.
Monitoring is via ARP.

Active backup works - it’s just that in some instances, the link flaps and we just want to make sure it’s stable before switching back.
This seems like a bug.

2

Two years later… The same issue exists. Seems not working. Still.

When is heavy raining, like a storm, which takes usually about 10-20 minutes, there is no sense to put link up when main is still flickering. Backup of 60 Ghz link by 5 Ghz link should switch again after main link becomes stable. If there is no algorytm for that, let us to decide about back to normal time. Otherwise is useless.

Regards,
syd