The question is in subject.
Write in terminal
interface wireless print
Choose the number of your wireless interface (ex = 0) and write again in terminal
log info [/interface wireless get number=0 tx-power]
You should see in the log window the CURRENT TX POWER…
It shows TX power set if wireless interface tx power is “card rates”
if tx-power is set as default it doesn’t show nothing.
I’m near to a check by communication autority and want to be sure about ETSI compliance…
Winbox shows CURRENT TX POWER values out of any reason.
Two equals cards (r52n) on same routerboard 433 with same “Antenna gain” shows different CURRENT TX POWER values!
/interface wireless print advanced