AP and bridge setting

RouterOS Wireless Networking
1

AP and bridge setting
I have two ARGtek 802.11b/g Outdoor Wireless 400mW 26dBm High Power CPE/AP/Router/Clint/Bridge/Repeater or ARG CPE2615 (http://www.argtek.com/style/content/...2625&id=131517).

both of these are in bridge opration mode.

the first one called device A and connected to wired router set as AP

the second one is called device B and set as client. B is connected to A, then B has repeater for A WiFi signal.

the problem that is all clients that is conected B repeater apear to have the MAC address of the repeater. I want every client has it owns MAC

2

these picture show what I want to say :
-Wired router instead of DSL modem
-device A instead of the Wireless router
-device B instead of the wireless repeater

device A and B are in bridge mode so all users get IP addresses from the wired router.


the MAC addresses fror the people connected to device A is thier own MAC but the MAC address for the people connected to device B is device B MAC address.

I want all client to show all MACs

I read that I can do this usinge WDS but I don’t know how. Also it say that WDS make signal weaker.