AP isolation

RouterOS Wireless Networking
1

Is it possible to configure AP isolation or Wireless isolation?, so that mi wireless clients cannot “see” each other.

RouterBoard 532 with a Prism 200mw wireless card.

Thanks!.

2

Set “default-forwarding=no” on your wireless interface…

Best regards,
Christian Meis

3

Thanks a lot. That did it!.

4

but i think this works only for one wireless card, right?

how to do, if you have two cards on an AP ??
Is it also possible to isolate them?
Or with two AP in one network?

5

It is possible with basic knowledge of networking…everything else is in manual…

6

hello

i’m using a bridge of 2 D-link 2100 AP , first connected to MT , second is connected to a switch ,an outdoor AP with omni connected to the switch, about 7 users are connected to the switch by wires , this is my setup ..

1- do the 2100AP is capable to handle this trafick ? total is 30+ users..
2- is it ok with the switch setup ? 2100AP-switch-AP-25 wirless users and the same switch- 7 lan users ??

please need some help..