Atheros 5213 will not work after assign to a bridge - 2.8.26

RouterOS General
1

after I assign my wlan and ether it will stop communicating while it is associating with the other AP either in station mode or ap-bridge, why?

today I went to another shopping centre and trying 10 more brands and only this gigabyte 108 mb was detected by mt but now it doesn’t work in bridge mode…

Thanks

2

You can not bridge wireless client. Its not on the card, its on RFC. You can read a lot of about it if you look after wds and eoip tunnels. That gigabyte card works fine for us.