Audience configuration

RouterOS Beginner Basics
1

So, I’ve been slowly migrating from Ubiquity to MikroTik over the past few months and have just yesterday received my first Audience.
While I can appreciate the phone software for configuration, I really, really don’t want to configure the whole thing like this and would prefer to use my PC on my existing, firewalled network.

For now, I really only have two goals, and have been stumped for the past day; I’ve probably reset this thing about a dozen times already.

My goals are as follows;

  1. Allow access to the web interface via LAN2
  2. Dedicate LAN2 as a management network interface

Again, my network is already firewalled (though not with the best of hardware), and I will be configuring VLANs in the future to further secure and segregate the different networks.

I’m sure I’m probably missing something stupid simple, but if anyone can point me to any resources and/or terminology that will guide me to the answers I’m after, I’d greatly appreciate it.

Thanks!