Bandwith Problem Mikrotik to Mikrotik using Airfiber Links

RouterOS General
1

I have a big problem I’m running this scenario

Site A :CCR Ver 6.28 with and AirFiber linking to Site B

Site B : Rb1100xa Ver.5.20 with and AirFiber Linking to Site A


Wen i do a BT on Site B receiving from Site A i only get 10MB to 60MB

Wen i do a BT on Site A Sending to Site B i only get 10MB to 60MB

But wen i do a BT on Site B sending to Site A i get 400MB+

and also wen i do a BT on Site A Receiving from Site B i get 400MB

I also have same scenario on another site Linking with another airfiber from Site B

2

Anyone?

3

Are you sure actual AirFibers link capacity is symmetric?

4

Yes!

5

Are there any queues set up on the mikrotiks? can you check the log for ethernet interfaces negotiated rates?

Could you post screenshots of both airfibers status?

6

Before proceeding with the tests. Maybe try updating the firmware on router site B. As this seems to be the common problem and maybe a firmware issue.

7

i can try that updating , but its weird , also i have a SITE C that is connected to SITE B and wen i do the BT From C to B i also have the same problem BUT wen i do the BT from site C to Site A i have 300up and 300down .. really weird
AIRFIBER.JPG
Diagram.jpg

8

When you connect Site C to Site A is it going through Site Bor is there a switch at Site B.
This is looking very much like a firmware issue or a problem with Site B router. Can you confirm what speed your ports are set to on Site B. It may be worth while upgrading all to 6.29 and running the new fastrack feature.

9

Site A - CCR 6.28 Ether 1 has Airfiber to Site B

Site B Rb1100xa Ver 5.20 - Ether 1 has Airfiber to SITE A
Ether 2 has Airfiber to Site C

Site C Rbx86 ver 5.20 - Ether1 has Airfiber toSite B

Every router is doing OSPF , and yes Site C connects trough site B

10

I second dgnevans, guess there’s a reason for that router not to be upgraded to 6.x? Can you check its firmware? (System > Routerboard)