Basic IPv6 on LTE interface

RouterOS Beginner Basics
1

Hello all,

I’m looking simply get an IPv6 address on LTE interface. I do know that the provider does provide IPv6 address through DHCP and I must be able to assign that the the LTE interface or better passthrough. I try to configure but get the following message:

I am using this https://mikrotik.com/product/ltap_mini_lte_kit_us
Please let me know how I can get the IPv6 address on the LTE interface.

Thanks,
Jason

2

Just curious if you ever solved this.

Thanks

3

Hello,

i have a wAP ac LTE6 with the R11e-LTE6 Modem inside and got the same problem. I did lte passthrough to my main router (rb3011) over a vlan, so i still have management access to my wAP and can even use the capsman on my rb3011 to manage the wireless stuff. On the rb3011 i also got my main internet connection (dsl over pppoe) running with ipv4 and ipv6. Now i wanted to use the lte of the wAP as a second internet connection for e.g. load balancing and/or failover. Everything works good in case of ipv4, but i can’t get ipv6 running.

Is there any solution or workaround to use ipv4 AND ipv6 with lte passthrough? That would be great!

Thanks for your answers!

4

+1.

I just tested LTE with ipv6 and it works on my laptop (win10+lte modem).

If I try the same on mikrotik, where I do passthrough from SXT LTE 6 kit to RB4011, it does not work :(.

Makes me sad since wiki says both ipv4/ipv6 are supported. “The LTE Passthrough modem can pass both IPv4 and IPv6 addresses if that is supported by modem.” source: https://wiki.mikrotik.com/wiki/Manual:Interface/LTE?fbclid=IwAR3ERT779b6SF-THB9BSPnfIzGRi_t0JjGCYnYbkHsNIJ-x7FcaRLW4k8r8#Passthrough_Example

Thank you!
kaspik

5

I have same problem on Routeros AC3 with USB LTE Dongle.
Tested on stable version 6.48.4 and Dev version 7.1rc4.

6

kaspik write:

They not write that can be possible in the same time.. I think this should be reported directly to MikroTik at support@mikrotik.com or http://help.mikrotik.com

7

I did report it already in April… SUP-45199

It’s in “Pending” state since then.

8

When I have cases with status “WAITING FOR SUPPORT” then sometimes (1 a week) I type “Any news” and this helps :D.

9

snip.PNG

10

You Will just have to set ipv6 interface to bridge on apn settings and also turn off passthrough
This way the bridge interface auconfigures the ipv6 range on your lan without any DHCP servers
This totally works for me on hap ax lite LTE6