The part of the config you posted looks OK. How about DNS settings etc. Can you describe “can’t browse” a bit more exactly (problems, error messages, …)?
My client is working now. It was a cable problem. I am greatful.
But my client on Prism Wireless Card is having no singnal even with his PC at my base. Initially when I have those configuration and my base not mounted on the mast it was browsidng ok.
Anyway my mast is about 160ft and the Omni 15dbi Antena is at the very top. The other client with different antena is browsing but the one on the prism card (i.e IP address - 172.155.20.3) is not able to browse.
Please can any one check my configurations again and see if anythin is wrong.
[quote]These are the configurations on the access point.
Access Point
/ip address add address=192.116.66.69/27 interface=ether1 disabled=no
/ip address add address=172.155.20.1/24 interface=wlan1 disabled=no
/interface wireless set wlan1 ssid=Macwims band=2.4ghz-b/g frequency=2442 mode=ap
/ip route add gateway=192.116.66.65
/ip route add dst-address=192.168.0.0/24 gateway=172.155.20.2
/ip firewall src-nat add out-interface=ether1 action=masquerade
/ip firewall dst-address add action=nat dst-address=192.116.66.69/32 to-dst-address=172.155.20.3 [/quote]
Please I will appreciate a quich response.
Can anyone tell the maximum distance of the Prism Wireless Card from The Aceess Point. My Prism card finds the Network SSID but cannot ping the Acess Point. It times out.
Can anyone tell the maximum distance of the Prism Wireless Card from The Aceess Point. My Prism card finds the Network SSID but cannot ping the Acess Point. It times out.
You should use a link budget calculator for this. Distances depends on radio cards, antennas and loss in cables.
