Bonding 2 interfaces - waste of cable?

RouterOS General
1

hi

I had the idea to bond ether1 & ether2 to get 2Gbit/s between 1 MT1100ah and 1 CRS125 and create InterVLAN at the 1100AH (router on a stick).

Reading about technical design both devices allow only 1Gbit/s throughput towards CPU.

So bonding is a waste of cable and only for utilising fault tolerance?


many thanks!

2

If you use ports not on the same switch group then it is not waste of cable.

3

Can you give more detail on how to do this please as the CRS125 has only 1 switch chip whereas RB1100AHx2 has multiple switch chips…does this mean LACP is supported directly to the CRS125 Switch chip

CRS125-131112144104[1].pdf (80.3 KB)
Block-RB1100AHx2[1].pdf (31.2 KB)