Bonding between two ADLS Lines.

RouterOS Beginner Basics
1

Hi..

I am trying to setup bonding with EoIP tunnels between two ADSL Lines.

First ADSL Line (2mb) connected to ether1
ether1 address=192.168.1.50/24
ADLS Modem ip=192.168.1.1/24

Second ADSL Line (2mb) connected to ether3
ether1 address=192.168.2.50/24
ADLS Modem ip=192.168.2.1/24

ether2 connected to local network
ether2 address=172.16.10.1/18

Now i want to create an EoIP tunnel so that i can get maximum throughput, but i am unable to set it up.

Please provide some steps, how to accomplish this task.

2

Unless you have a Mikrotik or at least a Linux box on the other side of the link it won’t work.

3

Hi..

Dear JWCN,

Thanks for the information.

4

Mudasir, there’s also a nice tutorial on the training site for bridging remote networks using EOIP.

Maybe this will help you?

5

HI..

Can you please direct me to the exact link, it will become much easier for me.

6

this one? http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks_without_using_WDS_(EoIP)

7

Nice except that there’s nothing there yet :slight_smile:

I was thinking about this one, by Arnis;
http://training.mikrotik.com/course/category.php?id=2

Bridging Remote Networks at the bottom, but you’ll have to login to access it.

8

sorry, the link broke off. the article is there, just add one bracket )

http://tinyurl.com/6jbyc3

9

Thanks normis. I should have looked harder.

10

Hi…

It is still not the thing that i am looking for. As i said i have ADSL Modems on both ends. So i can not configure them to use EoIP. Is there any other solution.

11

If I may ask, why not? Just put them in bridge mode and run the pppoe from the routerboard.

Unless I’ve got the cat by the short and curlies.