Hello.
Does anybody use bonding on high-speed links?
We tried to bond two gigabit links in balance-rr mode, and after 50-200 minutes of uptime with >600 Mbps traffic router goes crazy: ping - >50% packet loss, traffic ~ 1 Mbps on both NICs… Only reboot helps…
Router is connected to D-Link 3100-24TG switch.
I had a total failure bonding 2 WLAN of 2 RB433.
Maybe using EoIP through those phisical interfaces and bonding the EoIPs would work better.
i did it succefully, check below link
http://forum.mikrotik.com/t/bonding-interface-with-cisco-2950-t/23801/1
what traffic bandwidth do you have over bonding?
p.s. ‘broadcast’ is failover mode. I need load-balance…