Bridge betwin vlan and wlan doesn't work.

RouterOS General
1

Need access to vlan by wifi.
Huawei s5700 switch port is configured to trunk with all vlans. Created vlan 105 on ether1 and bridge1. Added vlan 105 and wlan1 interfaces to bridge1.
I can connect to wifi, but I don’t get IP by DHCP. Set static IP address, default GW is not available.

Troubleshooting.
Deleted all interfaces from a bridge1, and deleted a the bridge1. Each test starts from this state.

  1. Created DHCP client on vlan 105 - client got IP address.
  2. Set switch port to access mode, created bridge1. Added ether1 and wlan1 interfaces to bridge1. Clients get IP address.
  3. Created vlan 105 on ether1, bridge1. Created DHCP client on bridge - bridge1 didn’t get IP address.