Bridge IP assignment from PPPoE interface to downstream device

[blangk]

Hello everyone,
I am sure there must be a way to do this but it has not worked for me yet
Basically I wish to use a Mikrotik to be PPPoE client but pass the IP from that to another device
Additionally, for this ISP PPPoE needs to be on VLAN 10
Is that possible, and if so what would be the best way to do it?
Thanks

[rplant]

It can be done, the following thread is worth looking at for this functionality:

Using RB5009 in bridge mode

Hello, I was recently given an RB5009 as my current Ubiquiti device blows with PPPoE and fiber, and is dropping a considerable amount of performance. I was told to put the RB5009 in bridge mode and let it create the PPPoE connection, and then put the other router behind it in DHCP mode to let it get the IP and avoid double NAT shenanigans. I can successfully use the RB5009 in router mode and get a connection and get full 2,5G down, but once in bridge mode it will not forward the IP to the sec…

[blangk]

This looks close to what I had been trying so good to know I was on the right path.
Thank you rplant. Sometimes it can be hard finding the right posts around here.