Bridge->Ports, Drivers (problem)

DedaMraz · February 5, 2006, 9:44am

Hi…

I use Lucent Orinoco Silver PCMCIA cards with PCI adapters. Wireless connection between two routers works just fine, but it can’t be seen in ‘Drivers’ or ‘Bridge->Ports’ section? Why is that?

Tnx

cibernet · February 5, 2006, 10:02am

What version of MT are you using?

DedaMraz · February 5, 2006, 10:36am

2.9.6

cibernet · February 5, 2006, 10:42am

Try to upgrade to 2.9.12 and see if that happen

Regards

DedaMraz · February 5, 2006, 11:28am

Same thing

cibernet · February 5, 2006, 11:30am

Do you see it on interfaces?

DedaMraz · February 5, 2006, 12:24pm

[admin@MikroTik] > interface print
Flags: X - disabled, D - dynamic, R - running

NAME TYPE RX-RATE TX-RATE MTU

0 R ether1 ether 0 0 1500
1 R wavelan1 wavelan 0 0 1500
[admin@MikroTik] >

[admin@MikroTik] > driver print
Flags: I - invalid, D - dynamic

DRIVER IRQ IO MEMORY ISDN-PROTOCOL

0 D 3com 3c59x PCI
[admin@MikroTik] >

...also, when trying to make a bridge, wavelan1 is not offered as interface, only ether1!

Maybe I sould say that the same problem occurred on both roters. One Orinoco Silver is connected over ISA adapter, and the other over PCI adapter.

cibernet · February 5, 2006, 12:27pm

DedaMraz:

cibernet:

Do you see it on interfaces?

[admin@MikroTik] > interface print
Flags: X - disabled, D - dynamic, R - running

NAME TYPE RX-RATE TX-RATE MTU

0 R ether1 ether 0 0 1500
1 R wavelan1 wavelan 0 0 1500
[admin@MikroTik] >

[admin@MikroTik] > driver print
Flags: I - invalid, D - dynamic

DRIVER IRQ IO MEMORY ISDN-PROTOCOL

0 D 3com 3c59x PCI
[admin@MikroTik] >

…also, when trying to make a bridge, wavelan1 is not offered as interface, only ether1!

Maybe I sould say that the same problem occurred on both roters. One Orinoco Silver is connected over ISA adapter, and the other over PCI adapter.

You should send a e-mail to support@mikrotik.com with support.rif they may have the answer to your problem

Regards