I just installed a pair of LHG60s which have a great link.
But I can’t seem to get proper bridging for only a few VLANs setup without bridging the PVID of the LHG60 itself and/or locking myself out.
I want each LHG60 to be in VLAN1/PVID1 (untagged) for (site-local-only!) management and then bridge two VLANs (i.e. 4001 and 4002) over the wireless link.
However, I always have VLAN1 bridged too, so I have L2 connectivity between the two sites on their mgmt networks.
Any suggestions how to set this up?
I already needed to factory reset the unit I have been playing around with four times because I locked my self out.