Hello My friends..!
so my problem like below…
while upgrading My CRS326 MT Switch the power is interrupted .
so the unite enter in an endless loob of booting without reaching to a stable point.
i use a Netinstall tool to flash the firmware and i use the MT version 7.8 arm architecture, so the process is done and i restored my device.
however when i change the booting mode to Switch OS, the switch returned back to its booting loop behavior.
so i reset the unite and it get back to a router mode.
but now i want to operate it as a Switch mode.
what i have to do in this case ..?
anyone encounter this..?
If I do not remember bad, after install RouterOS you can go on SwOS submenu and update the SwOS???
so do i have to Netinstalled ..?
or just updating it normally..?