Can I make a ap/bh-bridge on one radio

RouterOS General
1

I am looking to feed bandwidth from one level 3 cpe 411 board (xr5 5ghz card) up to a 411ah w/level 4 license which will then also act as an ap.
The goal is to keep from putting up two radios to do the job of BH and AP.

the other option is I could get a router board that handles two mini pci cards and set one to one frequency and the other to another frequency in the 5ghz spectrum then create a bridge/station bh on one and an AP-bridge/station network to customers on the other.

Is there anyway to have one cpe feed bandwidth to the ap? If so what mode? (ap_bridge, wds bridge, etc) I haven’t figured out what all the modes do.

I am running v3.25

Thanks in advance for any input

2

Try this:

http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks_without_using_WDS_(EoIP)

3

I don’t think that is what I’m looking for. I expect it will be one network but that one of the cpe’s will act as a bh to feed up the bandwidth. I’m told this will work fine in the short term but that I will experience performance issues at the network grows. Perhaps I don’t have to do anything for my initial setup.

I have another cpe coming in the mail so I’ll try to set one as the bh cpe and one just as a subscriber both connected to a third acting as ap and see how it goes.