Cannot get bridge working

RouterOS Beginner Basics
1

Hi there,

I have just received my first 2 RB333’s with 3.0rc13 on them. I have attempted to create a bridge between ether3 on each rb333 over the R52 wireless interfaces in each. I have followed the guide on the Wiki but so far I have not been successful.

I have UNIT-A’s R52 configured as a “bridge” and have WDS configured into the bridge “wds-bridge”
UNIT-B has it’s R52 configured as a “wds-station” and is part of a bridge called “wds-bridge”
Each bridge is configured with a unique IP in the same subnet and can ping itself.

The link comes up and an extra interface for WDS appears on UNIT-A, but I cannot ping accross the link. e.g. UNIT-A’s bridge IP is 192.168.69.1 and UNIT-B i 192.168.69.2 but I cannot from from UNIT-A to UNIT-B

Can anyone tell me where I might have gone wrong and point me in the right direction ?


Once i have this tackled I need to move up to getting VLAN’s to pass over the bridge.

2

hi

just want to know is that opther WDS that is aded on unit A , is that WDS also added to the bridge


vincent

3

Hi,

try to put MAC address of remote WDS in wireless>connect list and in access list. And the same for remote mikrotik.


Martín

4

Thanks,

Once I have had a coffee I will try your suggestions.

5

Hi!

it works?

American coffee jajaja.

6

Yes! Thanks guys, this works good.

It obviously needs it in the access list to start forwarding packets.

No, not American coffee, I am down in New Zealand we get the strong stuff.