Cant connect RB-411 point to point bridge mode!

RouterOS Wireless Networking
1

I cant successfully connect my RB411(v3.10) in bridge mode, here is my config after I reset them:

For RB411 (A):
IP Add:10.10.1.11(ether1)
Band:5Ghzturbo
Freq:5210mhz
SSID:Beam
Mode:station
Ports:ether1 & wlan1
Power:5dbm

For RB411 (B):
IP Add:10.10.1.12(ether1)
Band:5Ghzturbo
Freq:5210mhz
SSID:Beam
Mode:bridge
Ports:ether1 & wlan1
Power:5dbm




Note:They “register” each other. RSL is -83db, though they are only 2inches apart. When pinging, it times out.

2

Hi,

First Upgrade ROS and Bootloader to the avaible 5.15 Version
Second reset device, config again, Take a Look in the Log-file

If this have to be a P2P Connection Look here:
http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks

If it doent works Test without Turbo Mode
Does the Boards have L3 or L4?

Mistry7

3

You have IP addresses on the ethernet ports but nothing else?

You need to take the IP address off the ethernet port, create a bridge of the ethernet and wlan port on each unit, then give the bridge the IP address. This will get you farther.