I have a 5.8 mikrotik radio and it has been compromised. i have been screened out through nat plesse help me out. how can i get into my radio back.
i still know the user name and password. its just that i cant see it in winbox.
Any one has an answer to this.
i will be most garteful.
Use the console port.
FEWI, THANKS BUT I AM STILL HAVING A PROBLEM WITH THE RADIO,
I CANT CONNECT THRU CONSOLE.
I DONT KNOW HOW TO CONNECT WITH CONSOLE CABLE.PLEASE HELP ME OUT.
I CONNECTED THE SERIAL END TO THE BOARD AND THE RJ45 END TO MY LAPTOP BUT NO SIGNAL, I REVERSED IT STILL NO SIGNAL. PLEASE I NEED TO DO THIS AS SOON AS POSSIBLE. I AM REALLY ATUCK HERE.
THE BOARD IS A 600 SERIES.
BASICALLY JUST TEACH ME HOW TO ACCESS IT THRU CONSOLE.
AM I STILL GOING TO USE THE NORMAL ADMIN PASSWORD TO LOGHIN?
I AM SO USED TO WINBOX AND USERMAN. I HAVE NOT USED THE CONSOLE BEFORE.
WHAT TYPE OF CONSOLE? - SERIAL TO SERIAL OR RJ45 TORJ45(ROLL OVER)
THANKS IN ANTICIPATION.
HOPE TO READ FROM YOU SOON.
… or just connect using a different piece of equipment, connect with Radio, and use MAC Telnet, seeing as you know the admin password.
If you forgot the admin password, post me the board or a backup and i’ll tell you.
i have tried console and telnet but it would not just respond
the radio is cooected to a switch alongside other radios but only this radio will not ping.
please house, i want to reset the radio, please help me out.
how can i reset the radio or rather restore it back to a certain configuration
is there any thing physical reset bitton on the radio that i can use to reset the radio? cos there is a toggle switch beside the led. how can i use this to reset it.
IF I CONNECT THRU ANOTHER RADIO,
I PINGED THE INTERFACE IT REPLIED BUT WITH “net prohibited”
I TRIED TELNET AND MAC TELNET, IT SAYS CONNECTION REFUSED.
WHAT CAN I DO TO RESET IT.
I ALSO NEED THE CONFIGURATION SO I CAN SET IT UP AGAIN.
I HAVE 4 CARDS ON IT BUT I AM USING 3 ANTENNAS SO I WANT THE LAST ONE TO BRIDGE TO ONE OF THE CARD.
THANKS ALOT, I AM REALLY COUNTING ON YOU.
Use http://wiki.mikrotik.com/wiki/Manual:Netinstall NetInstall to rest to factory defaults.
Stop USING ALL CAPS and shouting.
Thanks House, i have been able to reset my device. God bless averyone