cAP Lite - access webfig via WAN

RouterOS Beginner Basics
1

Hey - I’m setting up a couple of cAP Lites and am struggling.

Basically I want to set them to bridge mode but retain access to webfig for both by going to their uplink IP, However I think this is blocked by default…

Obviously this makes sense for a router where the WAN is the open internet, but for cAP lite it sits behind the NAT of the router (a BT router in this case)

Is there a way to open up webfig on WAN (Uplink) port?

2

Hello!!

If the AP is in “bridge mode” you probably will have no rules in “/ip firewall filter”
If you reach the AP IP address from where you want to access, you need just know the service port (/ip service), ensure the service in enabled in the same place, and ensure you have no filter rules droping the traffic (Is you dont have any filter rule, everything will be allowed)

Regards,
Damián