CAP no longer accessible (winbox or webfig)

RouterOS Beginner Basics
1

Hello,

I have a capAC (high ceiling) attached to a 4011 RB; I accidentally applied the CAP configuration on the capAC using the Quickset!
I could no longer access the capAC; I also noticed that eth1 on the capAC is interface receiving an IP address from the router and not the bridge.
I configured CAPSMAN, added the router address as a CAPSMAN manager to the dhcp network settings; the result: the capAC broadcasts the wifi networks as instructed, but still not accessible.

Is there a solution? or do I have to get a very high ladder and reset the capAC?
Appreciate your support.

Nicolas.

2

Connect a PC to a switched port on RB4011 (so there’s no routing between PC and cAP ac) and use MAC connection in winbox. Alternatively connect PC directly to cAP ac (use cAP ac’ cable usually connecting it to RB4011).