Hello, My setup is following: RB4011—>Cisco Catalyst WS-C2960S-24PS-L-–>cAP ax. I have setup Capsman and all the wifi configuration with VLAN. If I connect cAP directly to the bridge ports on RB4011 then wifi user gets his IP served from DHCP. The problem is if I connect cAP to the Cisco switch th…

Ok, I have found the problem. It was in the Cisco configuration. I have made factory reset and then recreate new configuration with all the vlans and voala it works. Thank you all for your help.

Well, it seems from the limited info you have provided, that the issue is with the way the Cisco device is configured, because it works correctly when the switch is not involved. But it is impossible for anyone to tell you why it doesn't work, because you haven't given us any information about how …

RB4011 has LAN side configured as bridge with VLAN filtering enabled, Cisco is also configured as bridge on all ports with trunk mode enabled for vlans. Both are connected with ethernet cable.

Maybe someone else has better psychic powers than I do. I give up. I am not going to play 20 questions. https://www.co.kerr.tx.us/it/howtoreport.html [image] 2 connections On RB5009 General Yup, we need the complete picture to answer in an accurate and thor…

Here is RB4011 export with relevant parts RB4011.rsc (7.5 KB)

If you can't put in the effort to describe your problem, you are very unlikely to get any help here. I am not going to waste any more time on this, until you provide information about what worked (including how it was connected, which vlans work, and which don't work). Were you connected to the sa…

From How to Report Bugs Effectively Writing clearly is essential in a bug report. If the programmer can't tell what you meant, you might as well not have said anything. I get bug reports from all around the world. Many of them are from non-native English speakers, and a lot of those apologise for …

Ok Buckeye. Let’s say the facts then to be clear: RB4011 is the main router, WAN port ether1 connected to a cable modem, RB4011 is only DHCP server, RB4011 LAN bridge contains eth ports 2-8 and sfp port, VLAN filtering enabled, RB4011 and Cisco native vlan=1 Cisco switch connected from it’s port …

My working config: interface GigabitEthernet0/9 description RBR-232 switchport trunk allowed vlan 10-250 switchport mode trunk /snip interface Vlan1 no ip address shutdown ! ! interface Vlan99 ip address dhcp Nothing more is needed to make it work. Do not use Vlan1 in any config, it i…

[image] peterda: Do not use Vlan1 in any config, it is not needed, safe and can cause problems. That rule is not only applicable for Cisco. [image] The twelve Rules of Mikrotik Club Beginner Basics Preamble and disclaimer: The following is a set of Rule…

[image] atomant: Let’s say the facts then to be clear: RB4011 is the main router, WAN port ether1 connected to a cable modem, RB4011 is only DHCP server, RB4011 LAN bridge contains eth ports 2-8 and sfp port, VLAN filtering enabled, RB4011 and Cisco native vlan=1 Cisco switch connected from it…