CAPsMAN VAP problem

RouterOS Wireless Networking
1

Hello,

I’ve recently configured CAPsMAN for managing two AP’s. Everything is working fine but when trying to add additional Virtual AP on one of the cap’s, nothing happens at all. CAPsMAN is not adding any additional VAP.

Here’s my current config:

Provisioning:

Flags: X - disabled 
 0   radio-mac=E4:8D:8C:CB:7E:BD hw-supported-modes="" identity-regexp="" 
     common-name-regexp="" ip-address-ranges="" action=create-dynamic-enabled 
     master-configuration=guestAP-cfg slave-configurations="" name-format=cap 
     name-prefix="" 

 1   radio-mac=E4:8D:8C:9C:BB:0F hw-supported-modes="" identity-regexp="" 
     common-name-regexp="" ip-address-ranges="" action=create-dynamic-enabled 
     master-configuration=BiuroAP-cfg slave-configurations=guestAP2-cfg 
     name-format=cap name-prefix=""

Configuration:

 0 name="guestAP-cfg" mode=ap ssid="Stolarczyk" country=poland hw-retries=4 
   security=guestAP-security datapath=guest_vlan_700 channel=GuestAP-channel13 

 1 name="BiuroAP-cfg" mode=ap ssid="StolarczykNet" hide-ssid=yes country=poland 
   security=BiuroAP-security datapath=StolarczykNet channel=BiuroAP-channel1 

 2 name="guestAP2-cfg" mode=ap ssid="test" security=test datapath=guest_vlan_600

Datapath:

 0 name="guest_vlan_700" local-forwarding=yes vlan-mode=use-tag vlan-id=700 

 1 name="StolarczykNet" bridge=bridge-local 

 2 name="guest_vlan_600" local-forwarding=yes vlan-mode=use-tag vlan-id=600

VLAN:

 0 name="guest_vlan_700" local-forwarding=yes vlan-mode=use-tag vlan-id=700 

 1 name="StolarczykNet" bridge=bridge-local 

 2 name="guest_vlan_600" local-forwarding=yes vlan-mode=use-tag vlan-id=600

Any suggestions ?

2

Is there in CAP vlan to gateway defined?

3

Hello,
Have you associated vlan to an interface before ?
I’m not sure but,I think you must add the bridge in the corresponding Datapath of the vlan 600 and 700.