CCR 1016 as switch? Config help needed

RouterOS General
1

I’ve tried to look around for an answer, so if I missed something feel free to point me in the right direction.

Running on a private network. What to use CCR1016 more as a high powered switch using fast path.

External firewall provides a gateway address of 10.100.1.1.
Internally LAN spans 10.100.1.1 - 10.100.2.254

Not sure how to configure. I don’t need a firewall, would like the CCR to route the traffic. A some point, may need to set up VOIP on another subnet (10.100.3.x)

I would share the config I had but I completely wiped the CCR and haven’t gotten it loaded back up yet.

I could see and ping internally but didn’t have the right setup to get past the firewall

Thanks in advance.

2

There is no switch chip in CCR. You have to put interfaces in /bridge. (and it will use fast path in auto mode, if you don’t config to much to firewall, bridge filter etc)