CCR1009-8G-1S Partition problem

RouterOS General
1

Router was working normally, one day i restarted it and it got a kernel panic, i tried using netinstall with no result.
But after working around for 1 hour i discovered something very interesting.
1- If i repartition the RoS with 1 partition i get the same kernel panic error and corruption message.
2- If i repartition it with 2 partitions it works and it boots normally, it creates part0 and part1 with RoS installed on part0.
in system>resources i get only 64MB instead of the original 128MB.

If i do step 1 everything i can recreate the same error.
this was a brand new device, is the 128MB nand corrupted somewhere.
how can i restore it to 1 Partition only.

Thanks :slight_smile:

2

Any chance that you are installing a version lower than 6.20?
Also, have you updated the firmware to 3.19?

3

I tried 6.20, does the same error AND does a reboot loop; tried 6.7; 6.12 and 6.15 no luck either.
Yes routerBoot is 3.19, also tried downgrading the firmware with no luck.

any ideas?

4

It sounds like defective NAND. Best to email support directly and get it replaced.