CCR1036-12G-4S + Huawei E8231

RouterOS Beginner Basics
1

Hello.
Recently i bought 4G modem Huawei E8231 with SIM. I just need to send sms, but when i plug in modem i see lte1 interface, and no usb ports. DHCP client receives the IP address from lte1.
There is some info about it:
/system> /system resource usb print

DEVICE VENDOR NAME SPEED

0 2:1 Linux 3.3.5 ohci_hcd Tile-Gx OHCI 12 Mbps
1 1:1 Linux 3.3.5 ehci_hcd Tile-Gx EHCI 480 Mbps
2 1:6 USB 2.0 Hub 480 Mbps
3 1:7 General USB Flash Disk 480 Mbps
4 1:10 HUAWEI HUAWEI Mobile 480 Mbps
5 1:8 USB 2.0 Hub 480 Mbps

/port print
Flags: I - inactive

DEVICE NAME CHANNELS USED-BY BAUD-RATE

0 serial0 1 Serial Console auto
1 serial1 1 auto

I tried to connect via usb hub (thought may not have enough power)- no effect.
Sorry for my poor english.
I would be grateful for any information.

2

:frowning:
so am i

3

[m@s] /tool sms> /system serial-terminal serial0 channel=0

[Ctrl-A is the prefix key]

at+cpin?
+CPIN: READY

at+cfun=0
OK
at+cfun=1
OK
at+cpin=1234
OK
at+cpin?
+CPIN: READY

at+gmi
WAVECOM MODEM

OK
at+gmm
MULTIBAND 900E 1800

OK
ati
WAVECOM MODEM

MULTIBAND 900E 1800

OK
at+gmr
532a09gg.2C2 1828120 040802 18:22

at+cmgs=“2222222***”

test

+CMGS: 1

OK




[m@s] /tool sms> send serial0 channel=0 phone-number=2222**** message=go
failure: timeout



I’m just like you, I don’t know what you are.

4

you have modem firmware named ‘hlink’ in this firmaware modem acts as router, you need change firmware of the modem to ppp mode (named ‘stick’) and you will get access to usb ports, sms and so on.