Hey,
We have recently - start of december - put two CCR1072-1G-8S+'s into production. And both of them have been having issues where the router just freezes up and have to be power cycled to get up again.
Both of them have crashed using the latest stable, v6.46. Today we downgraded to v6.44.6 longterm, thinking this may be a software issue.
But, one of the routers just crashed again.
Anyone had similar problems with their 1072’s ?
Please send a supout.rif file from the device to the MikroTik support.
We were faced issues on CCR1009 with ipsec AES-256. We had no freeze, was loop: boot - kernel failure - reboot.
Try 3DES if you have such case.
Pretty sure thats not our problem since we are not using VPN on these.
I’ve sent supout’s from both affected systems to support and will see what they say.
One thing we did notice is that we are using LACP on the LAN side on these (connected to Cisco Nexus 5548s).
The old 1036 we’ve had in production for around 6 month with about the same config isn’t running LACP.