Cisco VLAN to Mikrotik

RouterOS Beginner Basics
1

Hi!
I should replace one old cisco switch. I bought a CRS326-24G-2S+RM.
I can make just half hour down on the site, so the configuration should be good.

I have exported the cisco config:

no file verify auto
spanning-tree mode pvst
spanning-tree extend system-id
!
vlan internal allocation policy ascending
!
interface Port-channel1
 switchport mode trunk
!
interface Port-channel2
 switchport mode trunk
!
interface Port-channel5
 switchport mode trunk
!
interface GigabitEthernet0/1
 spanning-tree portfast
!
interface GigabitEthernet0/2
 spanning-tree portfast
!
interface GigabitEthernet0/3
 switchport mode access
 spanning-tree portfast
!
interface GigabitEthernet0/4 
 switchport access vlan 54
 switchport mode access
 spanning-tree portfast
!
interface GigabitEthernet0/5
 spanning-tree portfast
!
interface GigabitEthernet0/6
 spanning-tree portfast
!
....
!
interface GigabitEthernet0/28 
 switchport access vlan 57
 switchport mode access
 spanning-tree portfast
!
interface GigabitEthernet0/29
 spanning-tree portfast
!
interface GigabitEthernet0/30 
 switchport access vlan 55
 switchport mode access
 spanning-tree portfast
!
interface GigabitEthernet0/31
 switchport mode trunk
 spanning-tree portfast
!
interface GigabitEthernet0/32 
 switchport access vlan 56
 switchport mode access
 spanning-tree portfast
!
interface GigabitEthernet0/39
 spanning-tree portfast
!
....
!
interface GigabitEthernet0/43
 switchport mode trunk
 channel-group 2 mode on
 spanning-tree portfast
!
interface GigabitEthernet0/44
 switchport mode trunk
 channel-group 2 mode on
 spanning-tree portfast
!
interface GigabitEthernet0/45
 switchport mode trunk
 channel-group 1 mode on
 spanning-tree portfast
!
interface GigabitEthernet0/46
 switchport mode trunk
 channel-group 1 mode on
 spanning-tree portfast
!
interface GigabitEthernet0/47
 switchport mode trunk
 channel-group 5 mode on
 spanning-tree portfast
!
interface GigabitEthernet0/48
 switchport mode trunk
 channel-group 5 mode on
 spanning-tree portfast
!
interface Vlan1
 ip address 192.168.30.48 255.255.255.0
 no ip route-cache
!
ip default-gateway 192.168.30.254
ip http server

What I already created:
(Recreating because the whole was wrong…)



Is this enough for make it work?
(I cant try it too many times, because of the timeframe… :/)
Thank you!

2

All wrong. Have a (very good) look at this tutorial: http://forum.mikrotik.com/t/using-routeros-to-vlan-your-network/126489/1

Your “ROSish” cludge doesn’t seem to follow Cisco config (not closely at least), so I’m not trying to show correct config tor MT. If you won’t be able to get it right after reading (and understanding) the tutorial linked, come back and explain (in plain English) your goals.