Hi
Greetings to everybody
I know that this problem is mentioned many times but I did not find a solution
Devices are ccr2004-16g-2s and hAP ac3 as AP (on ccr2004 ether2)
I am trying to separate my networks
The problem is that i can not make two vlans to communicate
clients are getting ip addresses properly
Currently, there is no firewall rules
In the attachment is the current config
Thank you very much for your time
config.rsc (11.9 KB)
How to setup vlans on main router… → http://forum.mikrotik.com/t/using-routeros-to-vlan-your-network/126489/1
How to add MT device as AP/switch → https://forum.mikrotik.com/viewtopic.php?t=182276
Thank you anav for your quick response
I will read the articles and try today or tomorrow
Hi
I have read both articles
I did not succeed
For now, I am focused on the main router ccr2004 and tried many times to apply and adjust settings from the first link http://forum.mikrotik.com/t/using-routeros-to-vlan-your-network/126489/1
In the attachment is the latest config for router ccr2004 with added firewall rules to try to make two vlans to communicate with each other (for start all traffic)
As mentioned in my first post DHCP works well for all clients and all vlans
thanx again for helping me to solve the problem
ccr2004_config.rsc (12.8 KB)
hi everyone,
Finally, I have made some corrections so now I can communicate between 2 VLANs
Under IP DHCP NETWORK was an error in the gateway address and I set the setting for the bridge to use firewall rules to yes
Of course, to make it work firewall rules are added
anav, thank you for your help, articles you suggested are a great guide
bye