You have one excess space (you were tricked by the font used on the device), it is a RB2011:
https://mikrotik.com/product/RB2011UiAS-2HnD-IN#fndtn-specifications
Configuring it needs some minimal knowledge of RouterOS.
That particular device has besides the SFP, 5 Gigabit/1000 ports and 5 100mbit ones, and two switch chips so it can be tricky to configure properly.
Check its diagram:
https://cdn.mikrotik.com/web-assets/product_files/Block-RB2011UAS-2HnD_130546.pdf
If you can do with not using ether1, it might be easy to run the QuickSet as in here:
https://qlr.ro/mikrotik-rb2011-initial-configuration/
If you follow the above you will end up with the two (normal and guest, this latter optional) wi-fi’s (wlan1 and wlan2) the SFP and the two bridges master ports in a bridge (all together) configuration, with ether1 kept separate.
Then it can be refined, but the base should work.
You will need to get Winbox and get minimally familiar with it, and - in order to more easily exchange info on the board - learn to use its terminal to export the configuration (and post it here for review), the instructions are here:
http://forum.mikrotik.com/t/forum-rules/173010/1