Configuring a Wireless Wire Dish as a switch ?

RouterOS Wireless Networking
1

Hello,

I hope my question will not sound too stupid for experienced people but in a PtP setup linking a secondary building to a main one where all resources (DHCP server, WAN, …) are located, is it possible to configure both master and slave units of Wireless Wire Dish as switches ?

WAN ---- Main switch ----- Master dish ------ Slave Dish ---- Secondary switch

Best regards

2

Not sure I understand correct, but there is only 1 Ethernet interface on these devices?

However, you can connect a switch on both sides of it

3

What you need is a Bridge config, and the Dish set Is a P2P Bridge out of Box