Configuring IPsec - error "used the isakmp port"

RouterOS General
1

Dear I am having my first experience using IPsec, but have not got a exito.Tenho RB1100 in version 5.6 and need to close the tunnel with a Cisco ASA, I have set up a tunnel using pptp with another RB when active and IPsec to connection to the Cisco ASA, I am receiving many messages in the log type: ipsec, debug 192.168.1.1 [500] used the isakmp port (fd = 36) and is not established any connection between the endpoints. In case my question is whether this error has to do with the tunnel that already have established. Cause I need IPSec and PPTP tunnel running on the same machine if possible of course.

Note: To perform the configuration information used in the following link: http://wiki.mikrotik.com/wiki/Manual:IP/IPsec

Since I am already grateful for the attention.

2

Thank you all for your attention, because the problem was solved by modifying the ip address on the tip of the Cisco ASA that was wrong.

3

thanks for sharing the solution