I have RB600 with 2 wlans, 3 ether. i want to configure it for wireless access point and hotspot on the same rb.
i want a situation where the 2 wlans to be seen by outside clients, and to be controlled by one hotspot in the same router.
This is what i want to achieve.
Internet -------ether1------ (hotspot) -wlan1+wlan2
Did you tried to find this in the forum or wiki?!
This is a configuration that you can read in the beginners basics forum…
Let’s go..
Make a bridge with wlan1 and wlan2
Make hotspot in this bridge
Taraaaaaaaaaaan! : D!
i did make wlan1 and wlan2 as bridge, but yet wen i put d ip address, it takes d address of the ether1 as routing address, and the dhcp takes d same ip range.
if u have such configuration in the wiki, plz send me d link
You only have to put the IP to ether1, make the bridge and click on the “setup” button in ip/hotspot.
can u help give me configuration examples, ss my case is.
The bridged interface, wil it not carry any ip address? Then the nating and other firewall settings comes from where, hw will the clients get their ip addresses from.
Thanks
Did you tried to make what I said?
LOOK:
http://www.google.es/search?hl=es&source=hp&q=configure+hotspot+with+mikrotik&meta=&aq=f&oq=
http://wiki.mikrotik.com/wiki/How_to_make_a_HotSpot_gateway
http://wiki.mikrotik.com/wiki/Hotspot_server_setup
http://mikrotikvideo.blogspot.com/2008/01/basic-beginner-manual-for-hotspot-setup.html
http://www.marlwifi.org.nz/projects/basic-mt-hotspot
I have tried all the links, they did not explain my situation.
I have resorted to try another way may be that will be helpful.
I want to install the MT/Hostspot in a pc. But I want to use the wlan1 and wlan as acess points, How do i now bridge the 3 interfaces to gether.
The method for ether1 and wlan, i have set it up but i cant achieve the same for 2 wlan and 1 ether1. Any Help will be appriciated.
Thanks