Cpe Configuration

RouterOS Wireless Networking
1

Hi,
I need to know how to configure a cpe with RB 411.

This is my network:

VPN (PPPoE) concentrator

Access Point

CPE


CPE has to be configured as a client bridge.
Thanks in advance.

Levis

2

Read the manual

3

There’s nothing worse that a forum member always saying READ THE MANUAL DUDE!

Cmon. This is supposed to be a community for help, not an elitist club.

A more appropriate (and appreciated) response might be…

“This is too vague a question and would require a detailed and all inclusive answer. Perhaps you can make an attempt to program a CPE, and ask more specific questions after your attempt.”

4

There is a reason why you have “newbie” under your forum name.

5

If all your post are like the one above. Well, you know what you are.

6

Thanks DesertTek,

I’ ll try to configure by myself and I’ll post more detailed questions.

Thanks again :wink:

Levis

7

As long as your PPPoE concentrator is on the same bridge as your AP you should be good. Set your CPE card to “station” mode. Setup a PPPoE client on your wlan1 with the proper username/password settings. Setup DHCP server on your ethernet. Setup NATing in your firewall rules.

Eric

8

Hi,

I created a bridge and assigned wlan1 and ethernet interfaces to it.
Wlan1 in station mode without pppoe client: a router beside the cpe will be my pppoe client.
I 'll try so.

Thanks,

levis