cpu frequency problem.

Hardware MikroTik hardware general
1

hi
i can’t set frequency mode to 333mhz on rb 532
after reboot frequency is always 266

i set
/system routerboard settings set cpu-frequency=333
and it shows

baud-rate: 115200
boot-delay: 1s
boot-device: nand
enter-setup-on: any-key
cpu-mode: regular
memory-test: no
cpu-frequency: 333MHz
safe-cpu-frequency: 266MHz
boot-protocol: bootp
enable-jumper-reset: yes

and after reboot is still 266mhz

baud-rate: 115200
boot-delay: 1s
boot-device: nand
enter-setup-on: any-key
cpu-mode: regular
memory-test: no
cpu-frequency: 266MHz
safe-cpu-frequency: 266MHz
boot-protocol: bootp
enable-jumper-reset: yes



when i do keep-frequency then allways is drop to 266mhz

any sugestions??

2

you should set the CPU to 333Mhz, then shut it down. Take the power out and plug it back in. After that you can use keep-cpu-frequency.

3

no
:slight_smile:

i think there is problem when i use terminal via winbox
when i set via telnet or ssh all is ok

i think there is problem with winbox …

now i try set scheduler via telnet
maybe also it will work

4

I did it via winbox terminal and it works fine. You do have to pull the power, if it reboots without power-down it will come back up at 266
Was running 2.9.1

Regards